During the construction and positioning of Aluminum Rooftop Solar Mounting, it must be ensured that the front and rear pillars of the steel pile are on the same straight line, and the straight line formed by the front and rear pillars should be the same as the front and rear pillars. Straight lines are vertical. In addition, the straight line should not be bent, and the bending amount should be within 2mm.

There are also corresponding requirements for the height of the steel pile, and the height of the top end should be at the same level. The distance between the adjacent foundation centers of the front and rear pillars of the steel pile is about 3 meters, and the distance between the front pillar and the rear pillar is about 2 meters. The center of the welding plate on the upper edge of the front pillar must be at the same level, and the front pillar can be fixed after the corresponding length in the steel pile is reserved. Determine the approximate angle of installation according to the inclination angle required by the drawing, and at the same time ensure that the center of the welding plate on the upper edge of the rear pillar is consistent in height, and the rear pillar can be fixed after reserving the length in the steel pile. After the front and rear pillars are fixed, it is very important to install the longitudinal beam on the connecting plate. The center line of the longitudinal beam must coincide with the center line of the front and rear pillars. Next is the installation of the diagonal bracing: one end of the diagonal bracing is connected to the longitudinal beam, while the other end is connected to the pillar with a hoop, and the position of the longitudinal beam must be in a state of being parallel to each other.

The installation of the Aluminum Rooftop Solar Mounting is not difficult, and the parts must be assembled according to the instructions or design drawings. Tighten the screws with the appropriate force with a wrench. Remember to put the steps of the post-installation brace at the end.