When the inclination angle of Aluminum Rooftop Solar Mounting is certain, increasing the spacing will reduce the loss of shadow shading, thereby increasing the solar radiation area. According to a large number of engineering examples, the amount of steel used for fixed brackets (components arranged in large arrays) is higher than that of fixed brackets (components arranged in small arrays).

The surface of the stent should be coated with anti-corrosion, so there will be no cracking and shedding. If it occurs, it should be brushed in time. Others need to comprehensively consider the material of the stent used and the conditions of use. If necessary, some methods need to be used to fix especially some small roof support equipment. The construction of the project may not take a long time, but it will take a long time to detect the parameters, and try to avoid errors.

The modules are laid parallel to the roof slope, and the angle of inclination can be measured using an angle measuring instrument. The optimal inclination angle of the system is close to the local latitude angle or according to the roof structure. The spacing between the front and rear rows of the module: If you want to generate high power, you must control the spacing, and the spacing should not be blocked. The accessory channel steel and angle iron will produce stress deformation during the welding process. In order to prevent the stress deformation, the brackets should be spot-welded first. After confirming that they meet the requirements, temporary supports are added to the appropriate parts and then welded and fixed.

The firmness should be able to withstand the pressure of continuous load, wind, snow, earthquake and other external forces. Fasten the module with bolts, first fix the bracket on the roof, then install the solar module on the bracket, pass the screw through the flat gasket module and the mounting hole of the bracket frame. The screw is then passed through the flat washer and spring washer, and then the nut is tightened. The material of this Aluminum Rooftop Solar Mounting bracket is mostly made of angle steel, channel steel and square steel. Due to the low production process demand, its price is often relatively cheap; this kind of bracket can be widely used in the market due to its relatively good connection strength. bracket.